Webster IRP 4500 Guía de instalación descargar pdf (Pagina 20)

Interactive Rear Projection (IRP)

18 INSTALLING THE IRP 4500

HOST COMPUTER CONNECTIONS IN THE CONSOLE (OPTIONAL)

Ordinarily, you will be powering the computer on and off along with

the entire system using the IRP 4500 MAIN POWER switch located on

the power panel, on the left side of the console.

To route cables in the IRP 4500 console:

1 If you choose to put your host computer in the PC compartment

of the IRP 4500 console, assure that the computer will fit

comfortably in the space to allow adequate access for reaching

switches, seeing lights, and connecting cables. It will be most

convenient if your cable connectors are at the rear of the

compartment for access through the access panel in the rear.

2 Connect the COMPUTER POWER supply cord pre-wired in that

area to your computer.

3 Connect the VGA cable supplied with the IRP 4500 between your

computer and your projector (refer to your projector manual for

information about connections).

4 If you want to use your computer display monitor for an auxiliary

display, connect your original VGA cable between your monitor

and the projector.

5 Place your computer keyboard and mouse on the IRP 4500

keyboard tray (refer to “Installing the Optional Keyboard/Mouse

Tray” on page 11) and connect the cables to your host computer.

Depending on the location of these components, it may be

necessary for you to obtain extension cables for your keyboard

and/or mouse.

6 You can put other accessory equipment of your own choosing in

the accessory compartment of the IRP 4500 console if it does

not get too crowded. You can connect the AC power supply cord

pre-wired in that area to your accessory equipment.

IRP_Install_1.fm Page 18 Monday, February 3, 2003 4:19 PM

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 50 51

Sin comentarios

Webster IRP 4500 Guía de instalación Pagina 20